Entertaining outdoors used to mean just a gathering around your barbecue. With our range of premium wall mounted spillways, made from 316 stainless steel, it allows you to completely rethink how you can create your new focal point by designing your new water feature incorporating within pools, ponds, spas or rock features.
After all, there is nothing more soothing than the sight of a rippling or cascading water fall.
Made of high-quality 316 Marine grade stainless steel, it is chlorine- and salt water resistant, and thus highly durable. Assembly is quite easy.
-
Material: High strength 316 stainless steel backing bar, LED Strip, Clear Resin Filler
-
Finish: Stainless steel - finished back, Clear LED face
-
Dimensions: 300mm,600mm,900mm,1200mm,1500mm
-
Power Input: 230-240V, 50Hz Transformer include
-
Power Output: 10V - 1500mA 15VA
-
Lighting: 8 Colour variation LED with RGB Remote Controller(Battery Not Included - Require 1 x CR2025 or CR2032 Battery)
-
Cable Length: 5 metres
-
General LED light Bar Install Guide Included
-
Lip: 35mm
-
Material: 316 stainless steel
-
Inlet Size: For
- 600, 900mm : 1 x 25mm Female Threaded
-
1200, 1500mm : 2 x 25mm Female Treaded
-
Inlet Entry: Bottom
-
Warranty: 1-year Limited Manufacturer warranty
- General Install Guide Included
-
Note - Always read Instruction Manual thoroughly before installation. Pump not included.
-
The main difference between Marine Grade Stainless Steel and the Acrylic are:
o Both suitable for Chlorinated & Salt Water use
o Acrylic cannot expose to direct sunlight - more suitable for block wall set up eg. Besser block, brickworks
o Marine Grade Stainless Steel has a 35mm lip with larger opening( able to add extension lip to 150mm )- Acrylic has 25,40,125 & 135mm lip but smaller opening.
o Marine Grade Stainless Steel will provide a greater volume of water for the projecting sheet but projects lesser distance away from the wall. Acrylic can project further due to smaller lip opening but thinner projecting sheet hence will break off easier depending on the wind conditions.
o Marine Stainless Steel only have bottom inlets
o Acrylic has both bottom and back inlets with different lip size
-
Types of Spillway Effects
-
Cascade/Wall Wash - This is achieved where water flows softly from the spillway and cascades down the wall face into a pond or reservoir. A minimum flow rate of 50-60 Litres per minute (l/min) at the height of the spillway per metre of spillway length.
-
Projecting Curtain Sheet – This is achieved where a large volume of water passes through the spillway, producing a solid sheet of water that projects away from the wall. A minimum flow rate of 230 litres per minute (l/min) at the height of the spillway per metre of spillway length and the spillway installed no higher than 900mm from water level. Note - the further the water drops, the narrower the water sheet widths become due to surface tension. It’ll project between 80mm-200mm away from the lip – the final result depends on external factors, e.g. plumping, location and pump capacity.
